Discharge printing that uses a special water-based ink that has a “discharge agent” additive. When printed it and then put through an oven (dryer) it essentially bleaches out the dye in the fabric rather than other types of printing that cover up the colour of the fabric. “Discharge” is a method mainly used to accomplish soft prints. With care it also sometimes can be used as an underprint for traditional inks. The prints then also get even softer after washing.


For successful discharge printing on garment dyed fabric, follow these recommendations.



Create a customized graphic using professional graphics software. The graphic must be separated by colour, with each colour printed on its own clear film positive. Fewer colours mean a simpler set-up, resulting in lower costs. To enhance the softness of the shirt and to avoid printing problems as well, tone on tone artwork, utilization of distressed filters on the art, and tone on tone artwork and utilizing of distressed filters on the art and utilizing the shirt colour as a background colour in the design are good artwork tips.



Following a process that requires the use of a darkroom and photographic chemicals, a stencil, known as a screen, is made for each colour in the graphic image.


When printing garment dyed shirts, it is recommended to use inks and methods that avoid dye migration. Dye migration occurs when the dyes applied to the fabric move off the surface of the fabric into the inks applied. Always test your ink with Comfort Colours® garments for both dye migration issues and to make sure that the particular colour of shirt will “discharge” with your chosen ink. For best results use the recommended amount of discharge agent and then print within the time where the ink will remain activated (pot life), usually less than 24 hours. Make sure you have a long enough dwell time in your oven, as the discharge process occurs when the catalyst, humidity, and heat combine to “neutralize” the dye in the shirt. A gas oven with good airflow is usually the best for discharge inks. A hard squeegee or triple durometer squeegee can help drive the ink into the shirt fabric for better results. Discharge printing is better suited to direct/reactive dyed garments than pigment dyed garments. Most manufacturers have inks that prevent dye migration. We advise that you use them as necessary. Since there are many colours, many weather conditions, a variety of types of dryers and flashes, and artwork changes, there is no one “right” way to print these garments. In some cases a “low bleed” formulation will be effective, if problems still persist you need to use a dye blocking grey ink. In general use as little heat as possible while still curing the ink, that is both in terms of flashing and in your oven. In certain cases a longer flashing or drying time and lower heat levels are recommended. Additionally, the soft fibers of the shirts shorten the adhesion time to your platens. In order to maintain registration, reapplication of adhesive may have to be done more often.



Most inks fully cure when the entire ink reaches 320°F. We advise that you follow the specific guidelines provided by the ink manufacturers which usually define the optimal curing/ drying temperature and dwell time. Temperatures higher than 320°F and dwell times beyond the recommended settings can cause damage to the garments and/or inks. This time and temperature can change dramatically depending on the ambient temperature and the humidity of the shirts and based on the type of equipment.


It is strongly recommended not to overheat the garments at any stage of the screen printing process. Please ensure adequate ventilation in your screen printing facility and make sure to clean and maintain your equipment regularly.



  • Due to the nature of the dyeing process employed with Comfort Colours pigment dyed shades, loose pigments may remain on the surface of the garments. We therefore strongly recommend washing these garments only with like-coloured garments, as some of the pigment dyes may stain light or white coloured garments in the wash cycle.
  • Washing the garments in cold water will reduce the possibility of staining.


  • Dye migration occurs when the dye colour in the garment absorbs into the screen printed ink.
  • Ghosting is when printed shirts are stacked too soon during the drying process before being adequately cooled. This causes a chemical reaction which creates a ghosted image of a white screen print on the back of the shirt stacked on top.